Blog

IMPORTANT: Be sure to mark the center point of each newel post's location prior to installation to ensure proper spacing. All product interfaces must use PL Premium Adhesive (read directions before use) for warranty purposes and to ensure a lasting installation. Spectis makes no guarantee as to the suitability of our rail systems, or any other product we sell, on any specific project or application. Before any balustrade, or any other product, is ordered and installed, Spectis recommend …

Give your roof some decorative attention with well-placed brackets. The beauty of Spectis blocks and brackets can perk up a bungalow roofline, adding curb appeal to your home. Spectis Blocks and Brackets are high-density polyurethane (HDP) and can be finished to match exteriors either before or after installation. Step 1 Before ordering brackets, measure your eaves from the edge of the roof to the wall to determine the length of the top part of the bracket. Next, determine how many brackets you …

Elevating Construction Excellence: The Advantages of Spectis Urethane Building Materials Introduction: In the realm of construction, the choice of building materials holds paramount importance. Today, with sustainability, durability, and aesthetics taking center stage, builders are continually seeking innovative solutions. Spectis Urethane emerges as a frontrunner in this landscape, offering a blend of versatility, reliability, and eco-friendliness. Let's delve into the advantages that Spectis U …

IRON FLEX MOULDING INSTALLATION (INTERIOR/EXTERIOR USE) Spectis Moulders’ Iron Flex is installed using methods similar to those used to install Spectis’ Standard product.  Iron Flex can be installed using the following procedure: 1. Spectis Iron Flex can be installed over almost any clean interior or exterior surface. It should not be installed over wallpaper as the paper may separate or the adhesive may stain the wallpaper.  2. Moulding that has been stored in “hot&r …

Decorative Column Installation Instructions Spectis offers decorative columns, which can either be ordered with a one-piece shaft that can be used alone as a non-load-bearing member, or with the shaft split vertically to wrap around existing load-bearing members. In addition, some column designs have the cap and base telescoping around the column shaft, while other designs have the cap and base attaching directly to the ends of the column shaft (non-telescoping). They can be installed using seve …